how to dismantle long strap

- Nov 21, 2017-

Before unpacking, first roughly measure, in the end how many section removed the strap is appropriate:

      1. The ring strap temporarily removed from the clasp, so strap can be flat on the desktop. To facilitate the next move. The best bottom pad a velvet, you can protect the love table

      2. Strap the strap flat, with a pointed tool (I use a small pair of scissors) along the back of the strap arrow to find the location of the pin, against the round small bulge, outward in the direction of the arrow Push, push the pin.

      3. Remove the strap of the correct length, you can put the strap back. The latch may be a bit tight, looking for something moderately soft and hard (I'm using a plastic lighter) tap a few times, or push hard enough to get it back. Remember that the clasp is also installed yo.

     the watch band must first determine the watch with the grain is not connected by the screw but by the pin or cotter pin (also known as swollen ears) into

      Dispenser How to use: Place the watch strap in the groove of the drawer. Align the disassembly hole (also called thimble) with the disassembly hole on the side of the watchband by turning the handle clockwise as detailed below. Because the demolition of the needle as wearing parts, please keep the needle and the strap pin vertical, otherwise easily broken. Purchase price: 3 yuan / root


      1, most of the detachable strap in the back of the strap arrow signs, the pin can push the pin along the arrow direction;

      2, if there is no arrow mark can be observed hole pin tip surface, if it is flat, but also with a tight gap, we temporarily call A end, the other end is round end, we temporarily call B, We need to push the pin from B to A.

      Replacing the needle with the method of disassembly: Turn the handle of the disassembler counterclockwise, then pry the tail of the tail and separate the handle by a slit to remove the bad needle.

      Then install a new pin with a buckle and fasten the ring